EggRider Display

General Info: 

• Some customers may want to use an EggRider display with our kits 
• CYC supports (although not advised) using EggRider with our kits although note all below info 
• For use with ASI controllers only & not compatible with X6, X12, or Photon. 
• CYC does not supply EggRider displays directly 
• CYC only supports the use of EggRider displays by providing settings files and instructions on how to set it up accordingly 
• Any issue as a result of using EggRider or its software, will not be supported or warrantied 

Compatibility: 

• ASI BAC800 
• ASI BAC855 
• ASI BAC2000 

Converting an ASI file to be EggRider compatible: 

1. Connect to the BacDoor mobile app 
2. Load default voltage settings applicable to your motor & controller 
3. Change Display Protocol to "None" 
4. Change Assist Mode Source to "Network Gains 
5. Save to flash 
6. Export file 
7. Keep the default settings file name & only add "EggRider_" to the front of the file name 
   *some settings files may already be converted;  check for a matching existing file before creating a new one 

Setting up EggRider with ASI controllers: 

• There are specific steps to follow listed in a pdf that can be found here on teams: CYC EggRider Set Up Guide for ASI controllers.pdf 
• Ensure that the customer receives the correct settings file & the pdf doc. Add the disclaimer below. 

Disclaimer to add: 

Disclaimer: CYCMOTOR LTD may only supply the correct settings files and set-up instructions for the use of EggRider displays with ASI controllers specifically for the use of CYC motor systems. Any issue as a result of using this display or its software will not be warranted and troubleshooting support may be limited.